Latest News

For everything Ruralco and Real Farmer

12Dec

Dress well this summer

Nitrogen side-dressings encourage a good, strong canopy on summer crops and improve yields.

The amount of light a plant can photosynthesise has a direct effect on yield.

“Most photosynthesis occurs in the leaves, so a healthy, leafy canopy means the plant can capture more light and is more productive,” says Ballance Science Extension Officer Aimee Dawson. “A good canopy also cuts back on weeds and evaporation from the bare soil around the plant, so the plant can use all of the water and nutrients around it.”

Nitrogen is ideal for boosting leafy growth. For best results, side-dressings need to be individually timed for different crops’ high growth periods.

Brassicas

Apply nitrogen at sowing and side-dressing four to six weeks after sowing, when plants are about gumboot height. For leafy turnips, rape and other brassicas which can be grazed more than once, reapply after the first grazing.

Fodder beet

Fodder beets need to develop a strong canopy early on, to provide the plant with energy to grow the bulb. Apply a small amount of nitrogen (usually with starter fertiliser) at sowing. At canopy closure, usually around four to six weeks after sowing, use a single application. Recent research has shown no benefit from late applications of nitrogen on fodder beet yield.

Maize

Apply nitrogen at sowing and once maize reaches knee-height (the six-true leaf stage). This is often around four to six weeks after sowing.

Targeting nitrogen application to high growth periods, rather than later in the season, prevents the crop’s nitrate levels from getting too high, which could result in stock losses or reduced performance.

Getting the most from nitrogen

A bit of groundwork goes a long way in getting the best results from nitrogen. To effectively use nitrogen on your crop, it pays to know your yield, the soil’s nitrogen levels and to properly apply.

Know your yield

Maximises your return on your nitrogen investment by targeting your nitrogen application to your expected yield. Tools such as the AmaizeN calculator (for maize) or the Ballance Brassica Calculator are handy for refining your predicted yield. If you have cut corners during establishment, nitrogen side-dressings won’t help you catch up. When estimating yield, take into account whether the pH or nutrients for the crop at establishment were in the optimum range. Also take into account whether starter fertiliser was used (including boron for brassicas and fodder beet).

Know your soil

Testing to find out how much nitrogen your soil will supply to the crop allows you to work out how much to top-up from the bag. Soil on former pasture land may release quite a bit of nitrogen from built up organic matter when cultivated, whereas land cropped over a number of seasons may have low organic matter reserves. Organic matter mineralizes to mineral nitrogen during cultivation, causing the release of plant available nitrogen. For cereals, a mineral nitrogen or ‘deep N’ soil test to 600 mm can be taken prior to side-dressing to assess the nitrogen that is immediately available to the crop (as nitrate and ammonium). For brassicas and maize, an Available N test, taken to 150 mm, indicates the potential nitrogen that will be released over the growing season.

Apply with water

When applying nitrogen as urea, you need 5 to 10 mm of rain (or irrigated water) within 8 hours to get the nitrogen into the soil. Otherwise it losses occur into the air as ammonia gas (volatilisation). Volatilisation increases when there is low rainfall, high temperatures, high wind speed, high soil pH, bare or open soil or when high application rates are used. Volatilisation can exceed 30% when urea is used for side-dressing crops, mainly due to high application rates and open or bare ground. SustaiN is easy to use as you do not need certain rainfall conditions to apply it.  It also supports crop yield by helping to keep nitrogen in the soil for longer.

If you’ve done your groundwork, kept the weeds under control and used the right product but are still not getting the expected response, then use herbage tests to check for trace element deficiencies.

Related

No-till technology to keep the soil on your land

No-till technology to keep the soil on your land

To mark World Soil Day on 5 December, Ballance Agri-Nutrients Forage Specialist and no-till advocate...

Read More
Summer reads: Sisters under the Rising Sun

Summer reads: Sisters under the Rising Sun

In the midst of WWII, an English musician, Norah Chambers, places her eight-year-old daughter Sally ...

Read More
Regional fuel tax should be put on hold

Regional fuel tax should be put on hold

On 1 July 2018 the first regional fuel tax (RFT) allowed under law came into force in Auckland – an...

Read More
Harnessing the sun: embracing solar energy on farm

Harnessing the sun: embracing solar energy on farm

Now is the opportune time for farmers who are looking to secure their future energy, lower costs, an...

Read More
Looking at both sides of electricity equation

Looking at both sides of electricity equation

Over the past couple of years around the world “green” energy options have become very much the ma...

Read More
Hunting for the head

Hunting for the head

Rightly or wrongly, Level 4 lockdown saw the recreation of hunting despite its isolated nature and c...

Read More




Account Selector